IN WIN 904 Review

👤by David Mitchelson Comments 📅05-12-13

Transferring kit to 904 can be cumbersome in some regards and in others not so. When installing the motherboard, the 24-pin ATX connector was particularly difficult to plug into the motherboard due to the HDD cage sitting so close to the edge of the motherboard.

The length of your PSU is critical to both the installation of this device and additional cable management. Our FSP PSU is 160mm in length which is the ideal size for having enough clearance to allow the storage of redundant cables and for cables to even route from the PSU itself.

We’re pleased to see that IN WIN provide CPU power and 24-pin ATX extenders and plenty of cable management ties and clips. We had to make use of the CPU power extender since our cable would not reach.

ATX motherboard and system installed

Good cable management with extender cables

To install a storage drive into 904 a HDD tray is used. These trays can house 2.5” and 3.5” drives. A 2.5” drive will have screws attached to the underside while a 3.5” drive (like the one pictured) can sit into the tray without the need of attaching any screws.

Installation of storage

10 pages « < 6 7 8 9 > »