Kingston 10th Anniversary HyperX 16GB 2133MHz DDR3 Review

👤by Richard Weatherstone Comments 📅04-03-13
Specification & Features

Specification
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh 160ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 36ns (min.)
Maximum Operating Power 2.400 W* (per module)
UL Rating 94 V - 0
Operating Temperature 0C to 85C
Storage Temperature -55C to +100C


XMP TTiming Parameters
JEDEC: DDR3-1333 CL9-9-9 @1.5V
XMP Profile #1: DDR3-2133 CL11-12-11 @1.65V
XMP Profile #2: DDR3-1866 CL10-11-10 @1.65V


Features
JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 9, 8, 7, 6
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with
starting address 000 only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85C,
3.9us at 85C < TCASE < 95C
Asynchronous Reset
PCB : Height 1.18 (30mm) double sided component


11 pages 1 2 3 4 > »

Comments