After the recent P193 test the Tagan 900w PSU i had used needed to be removed.



Once it was out of the way all that was left before the CP-850 was installed was the removal of the ATX adapter plate.



As you can see this leaves a considerable hole ready to accept the CP-850.



Installation was very straight forward due to the size of the P193 - and once in place i found that the CP-850 had very generously long cables. A particular cable of note was the 8-pin 12v motherboard cable.



Originally the Tagan i first installed in the P193 caused me issues and i ended up routing the cable in open view across the motherboard and under the GPU. In stark contrast to this the CP-850 allowed me to use Antec's intended cable route making the install much tidier. I was very impressed!