Continuing our look at the inside of Ghost we come to the PCI section next. Here there are 7x PCI expansion slot covers, thumbscrews are provided separately. There is additional ventilation to the side and then directly above there are markings for grommets – these will need to be cut out of the case to make use of them.
7x PCI expansion slot covers
Moving up, there is a 120mm rear exhaust fan which is a Spectre 120 and at the top there are placements for dual 120/140mm cooling fans or a slim 240mm radiator (less than 3cm thick). As I’ve already mentioned and as you can see from the picture below, the top is quite open and susceptible to noise emission which is an odd design choice for a silent case.
Cooling options available at the top and rear
Over on the other side there are 3x 5.25” drive bays for adding in optical drives – all drives have a tool-less method for fixing the drives into place with a push/pull latch.
Immediately beneath the optical storage is the HDD storage. HDD storage is separated into two sections, a smaller 2.5” cage and a lower 3.5” cage. At the top of the 2.5” cage is a 3.5” slot for an optional device of choice to appear on the front panel of Ghost – this 2.5” cage is ideal for allowing good graphics card compatibility.
In total there are total of 7x HDD storage options available inside Ghost from both cages – to install a drive you simply need to drop the drive into a provided tray which are given in the packaging, we shall cover this in the next section.
Both cages are riveted and therefore without modding the front here there is no possibility of attaching water-cooling radiators.
Optical drive bays with tool-less design
HDD storage – 2.5” and 3.5” options
