An empty case only tells half the story so we show the installation to reveal any strengths and weaknesses. Being a mid-tower chassis our high-end ATX system is installed within Ghost.

Installation is pleasant but there are a few slight niggles. Before going ahead with the installation rubber grommets must be fitted to the motherboard cut-outs, this may not take that much time but it’s a hassle and because they aren’t factory fitted or tight the cable grommets do fall out when cables are pushed through so you have to be quite careful.

Apart from this hardware fits into the chassis thanks to the clearance. The tool-less options inside Ghost help to ease installation times too.





In order to install HDDs into Ghost 2.5” and 3.5” drives must be fitted inside one of the provided plastic trays. Both the 2.5” and 3.5” trays have pins that fit into the sides of the drives for a flush fixing. Thanks to this tool-less method the installation process is that bit easier and faster to perform.