Our usual practise is to observe memory clearance against the heatsink but since Water 2.0 Pro uses a pump this isnt a requirement.
Since most will be installing the radiator/fans in the rear exhaust position we are showing this in this section instead. Those who are using Water 2.0 Pro with anything other than LGA2011 will not have the issue of memory clearance with the radiator/fans since memory isnt found on the other side of the motherboard, but for LGA2011 as you can see this could be an issue if you have tall memory modules. Those with anything over 5.5cm will need to alter their memory configuration.
Memory clearance should be observed for LGA2011