Inside View 37 we have three cooling fans, all of which are 140mm – a rear exhaust and two front intakes, both are Riing Plus. This traditional method of cooling in a push-pull configuration usually yields good results.

To discover the thermal performance of View 37 we will record idle temperatures after 20 minutes from a cold boot. We will then stress the system and temperatures will again be monitored after 30 minutes have elapsed. The fan controller will be set to “high”.

For the purpose of accurate analysis, the idle and load temperatures for CPU will be recorded and the range between idle and load will be calculated to determine how efficient cooling is.

NOTE: Ambient temperature is 20C

System Components


Noise

Since the panels on View 37 are thick, noise is no issue with this case. We found it to be quiet on the “low” setting and noticeable on “high” but not disruptive.